[Yachts]

Due to blowouts and wanting to change my own brakes. I am now in possession of my own torque wrench of 600lb feet.. holy cow. Is it heavy

[encantotom]

yea, i carry one too.

tom

[Richard]

Marc,

Just want to reiterate it takes two people to properly use that wrench. One person on the grunt end of course, and the second person holds the wrenchhead at the nut. You won't get the proper torque without the second person AND you can get hurt using that much force if the socket slips off the nut

[Chester Stone]

May need a cheater pipe.

[kyleb]

I find it easy to properly torque the wheel nuts by myself - if I use the right accessory tool.

I made this out of 3/4" plywood. Just choose the slot that is closest to the nut you are working to support the extension close to the torque wrench. Works extremely well.

[Yachts]

I probably don't know what I'm talking about but mine twist and gets shorter or longer depending on the torque setting .the longer you make it the less torque you get. So wouldn't the cheater pipe defeat the torque setting?

[HoosierDaddy]

My automotive torque wrench clicks when it reaches the desired torque. A cheater bar would just require less force at the extended handle length to reach the desired torque setting. ie. If you set it for 100 ft/# it would require 50# of force at the end of the 2 foot handle. If you extend the handle to 4 foot it would then require 25#...................I think.

[kyleb]

All of the paperwork & instructions I have ever seen concerning torque wrenches clearly state DO NOT USE CHEATER BARS.

The torque wrench is calibrated to have force applied at the handle only. Any additional forces will yield false readings.

My 600 ft-lb torque wrench is long enough that I can lean on it to get the desired 450 ft-lbs for my wheels.

[ccjohnson]

I find it easy to properly torque the wheel nuts by myself - if I use the right accessory tool.

I made this out of 3/4" plywood. Just choose the slot that is closest to the nut you are working to support the extension close to the torque wrench. Works extremely well.

That is a great tool!  Probably a lot more steady than trying to hold extension in place by hand.  You need to apply for patent & sell this to large truck tire shops everywhere.  Don't forget us when you are rolling in cash! Let us know when you hit "Shark Tank" with it!