04-25-2023, 07:34 AM
The Outback VFX Inverters have a round filter that are pushed into place with nothing retaining them except friction. It falls out on rough roads and then don't accomplish any filtering. I was wondering if anyone has devised a way to retain them? I put a wad of Tacking Putty on each side as an experiment.
Access to the filter is by removing 4 screws holding the inverter front cover on (Phillips #2), the filter is under it.
Access to the filter is by removing 4 screws holding the inverter front cover on (Phillips #2), the filter is under it.
Jim
2014 Newell Coach 1482 Mid Entry 45'8" Valid Slides and Valid Levelling