You are not logged in or registered. Please login or register to use the full functionality of this board...
Newell Gurus
Engineer advice - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: General and or Other Stuff (https://newellgurus.com/forumdisplay.php?fid=16)
+--- Forum: General (https://newellgurus.com/forumdisplay.php?fid=21)
+--- Thread: Engineer advice (/showthread.php?tid=2747)

Pages: 1 2


Engineer advice - Yachts - 02-15-2016

On my trailers we are opening the rear door upward 90 degrees. Hinged at the top. Considering hydraulic Pistons or electric screw jacks.. Also am considering a torsion spring to assist.. Opinions from those smarter than me


RE: Engineer advice - Richard - 02-16-2016

Marc,

How heavy is the door?
Attach a sketch of how you plan to use the hyd cylinders or the electric actuators.

And you you want to up because?


RE: Engineer advice - pairodice - 02-16-2016

If you go UP then you would still need a ramp wouldn't you? I know your trailer drops down but is it enough that a Ferrari could get out the back without scraping? What about having the door fold or trifold up? Then you would not need as large of a mechanism... (???) These ideas are all free btw, so you get what you paid for :-).
The other consideration of having a door like that is the wind could catch it (?)


RE: Engineer advice - folivier - 02-16-2016

Since it's free advice....what about having the door split halfway up where the bottom drops down as a ramp and the top half hinges upward?
Which device would be faster and stronger electric screws or hydraulic?


RE: Engineer advice - HoosierDaddy - 02-16-2016

https://www.bifold.com/photos-page-garage-door.php


RE: Engineer advice - pairodice - 02-16-2016

Thanks HoosierD! Those doors are awesome! I finally know how I can hide my coach in a residential area!


RE: Engineer advice - Yachts - 02-17-2016

There is only a 4 inch lip which we have a small flap that takes care of it. Am considering bi fold as well. Just like the ides of a longer covered area.. Richard I'm working on a drawing to upload


RE: Engineer advice - pairodice - 02-17-2016

You are going to use the door as a sort of awning area?


RE: Engineer advice - Yachts - 02-17-2016

Yes sir that's the plan. One on each side also


RE: Engineer advice - HoosierDaddy - 02-18-2016

Marc, I am fascinated with this project and only have a shade tree engineering degree but as I was thinking about it one question I have would be about power availability. It seems that this setup would lend itself to being used frequently while unattached to the MH. If that is the case I would think battery draw to raise door would be an important consideration. Of course if you are planning for an on board generator that would be a non issue.