Valid Slide Seal Plumbing #1482 - Printable Version

+- Newell Gurus (https://newellgurus.com)
+-- Forum: Technical Discussions (https://newellgurus.com/forumdisplay.php?fid=3)
+--- Forum: Slides (https://newellgurus.com/forumdisplay.php?fid=55)
+---- Forum: Valid Slides (https://newellgurus.com/forumdisplay.php?fid=82)
+---- Thread: Valid Slide Seal Plumbing #1482 (/showthread.php?tid=6980)

---

RE: Valid Slide Seal Plumbing #1482 - hbens - 01-15-2023

Jim,

Nice to know your experiment worked! Sometimes all of this clean living pays off.

---

RE: Valid Slide Seal Plumbing #1482 - hypoxia - 01-15-2023

(01-14-2023, 10:30 AM)Parisjet Wrote:  I remember 40 years ago purchasing a kit where you could make o-rings from lengths of "Buna-N-rubber cord. It had a precise cutter and a V block to ensure that the ends were lined up correctly. There was a special glue Cyanoacrylate adhesive.  Those orings were so tough that you couldn't pull them apart.

I just looked it up and they still sell that kit at NAPA Part #: BK 7701018 Line: Balkamp or on Amazon Loctite 112 O-ring making kit which comes with a cleaning solvent and Locktite 404 glue

Now in my thinking, if you can make o rings from rubber rope material, why cant it work to repair a split in the slide seal?

Loctite 404 442-46551 0.333oz Quick Set Instant Adhesive, Clear Color  $38 on Amazon
L

I'll be looking at that.  The big problem is access.

---

RE: Valid Slide Seal Plumbing #1482 - hypoxia - 12-19-2023

One year since my rubber cement slide seal repair & NO leaks! 

---

RE: Valid Slide Seal Plumbing #1482 - BusNit - 12-19-2023

You are on a roll Jim! The air holding steady for almost 24hours makes you king in my book!

---

RE: Valid Slide Seal Plumbing #1482 - Richard - 12-19-2023

So………..

I had some extra slide seal left over from replacing the bedroom slide. I used the same Loctite as above and butt spliced two pieces together. That was last year. I chucked one end in the vise and pulled as hard as a could with pliers on the other end. I could not pull it apart or even cause a visible failure.

I left it in the Florida sun all summer while we traveled to see if UV would impact the glue.. I tried the vise/pliers exercise again when we returned. Again, I could not pull it apart. I also flexed it back and forth to see if the butt joint would open. It held fast.

I am impressed with this Loctite’s ability to weld rubber together.

---

RE: Valid Slide Seal Plumbing #1482 - hypoxia - 12-22-2023

Found a few more small leaks. After 29 hours the pressure is at 116 PSI so it's possible I'll wake up in the morning with the compressor still not ready to cycle. Doesn't take much to excite me!

---