[InfiLights]

Hello all,

Does anybody have a source for bezels on the square gauges over the driver ? ( Line voltages, amps, DC draw etc)
The gauge itself is held in place by the plastic front black bezel with 2 screws on the sides (inside) hooked in 2 thin metal retainers molded into the plastic of the bezel. When the side retainers break off ( and they do easily after a few years of heat) , the gauge falls inside the cabinet.
I could use 4 bezels......plan B is silicone on the back but I'd rather do it right if I can find the bezels.....

Any ideas ?

[bikestuff]

Marius,

I have a full set of gauges AC volts L1 L2, and Amps L1, and L2....is this what you are looking for?
My gauges quit working and I replaced the entire panel with new gauges from Blue Sea Systems.

Bill

[InfiLights]

Hi Bill,

Yes I saw that the Blue Sea gauges are identical except the Newell brand.
My gauges all function properly. They are not defective.
The thin, black, plastic bezel that trims the front of the rectangle hole and holds each gauge in the black plexiglass panel have broken tabs and the body of the gauge has no way to stay in its place. I am looking for the retaining system of the gauges into the panel.

Did Blue Sea sell bezel kits for those gauges you put on ? How are the Blue Sea gauges attached to the panel ? Different system ?

[bikestuff]

The blue sea gauges are different sizes than the old ones so I had Newell build a new panel. If I remember correctly, mine have no bezel...the black plastic around the gauge is part of the gauge....But my memory could be wrong.

I will be at coach in next week and will take a pic and see if I something you could use.

For those following.....The Blue Sea gauges have been completely flawless. (Other than not being the exact right size)