You are not logged in or registered. Please login or register to use the full functionality of this board...


Window Reinstall
#1

I pulled the salon slide windows out and will be cleaning them up and reinstalling soon. 
Any tips on what to watch for when reinstalling the windows?  What ‘caulk’ do I use?  I think the old sealant was Urethane like that used on car windows now - that is what I was planning to use again unless there are better options.  I can buy the Urethane in a roll or use the squeezy-tube stuff but it makes a bigger mess.  Any ideas are welcome. I will call Newell and get their input also.


Attached Files Thumbnail(s)
   

Karen & Adrian Abshire 
1998 2 slide 45' Newell Coach 498 
Prior: 1985 Foretravel ORED 35, 1988 38' Foretravel U280, 2000 Foretravel 42' U320, 1990 Bluebird Wanderlodge WB40
Reply
#2

I talked to Newell and they indicated that they use a ‘Butyl’ sealant on the windows - comes in a roll. This is what I had used previously on windshields and is pretty easy to use. Newell said they don’t use silicon (maybe Sikaflex if needed) because paint does not stick to it well.

Karen & Adrian Abshire 
1998 2 slide 45' Newell Coach 498 
Prior: 1985 Foretravel ORED 35, 1988 38' Foretravel U280, 2000 Foretravel 42' U320, 1990 Bluebird Wanderlodge WB40
Reply
#3

Adrian,
I used to install sunroofs in a previous life a few decades ago. To me windows are just vertical sunroofs. Butyl was what we used then and was pretty leak proof.
Start at the bottom middle of the window and go around from there. When you tighten the screws do them a little at a time and crisscross the pattern.
When we removed and reinstalled one, we tapped on the screw holes of the frame to tighten them up a little before installation.

Hank & Natalie Bensley
2001 Double Slide #586. 
2021 Cherokee Trailhawk Toad
Port Orange, FL. Upcoming Snowbirds in Endwell, NY Smile
Reply
#4

Adrian,
Here is a great website on the marine use of Butyl for bedding deck harware.....https://marinehowto.com/bed-it-tape/. Falls in line with "good enough for boats....good enough for a Newell"

Steve & Doris Denton
45' Newell #525, Bath & Half....sold
37' Country Coach, Tribute....Cat C9, 400 hp
2014 Honda CRV Toad
Summerfield, FL
Reply
#5

Thank you Hank and Steve! Great tip on starting at the bottom (to keep a solid seal at the top where the water comes in) Hank! I’ll check out the website but boats sink and Newells rarely ever do! Lol

Karen & Adrian Abshire 
1998 2 slide 45' Newell Coach 498 
Prior: 1985 Foretravel ORED 35, 1988 38' Foretravel U280, 2000 Foretravel 42' U320, 1990 Bluebird Wanderlodge WB40
Reply
#6

I used butyl whem replacing the rear view camera. It originally had a putty seal.I don't know about future removal. Perhaps piano wire ?

Guy & Sue
1984 Classic 40' #59
Reply
#7

Guy, use a windshield removal tool. $5 at HF!

1993 Newell (316) 45' 8V92,towing an Imperial open trailer or RnR custom built enclosed trailer. FMCA#232958 '67 Airstream Overlander 27' '67GTO,'76TransAm,'52Chevy panel, 2000 Corvette "Lingenfelter"modified, '23 Grand Cherokee.
Reply
#8

Thanks !
I frequent Harbor Freight, but never saw this item. Having basement air, removing the rear camera is the only way  I have to gain access to the rear a/c evaporator coil for cleaning.

Guy & Sue
1984 Classic 40' #59
Reply


Forum Jump:


Users browsing this thread: 5 Guest(s)