[Wanderman]

I am installing a Splendide Washer/Dryer Model 2100XC into the location where the stacked washer and dryer were.

Anyone know if I need a 90 degree elbow to get to the clutch cable controlled vent?

Also, do i need a plastic drip pan. There is a hole cut in the floor of the closet that just drops into the bay below. Did it have a drain and if so, where did it get plumbed to?

The hole is in the middle of the floor just out of frame on the first picture.

Thanks,

[Richard]

You are in uncharted territory.

[Wanderman]

Now that's a bummer! Even a photo of the space under the washer/dryer closet may help if there is a pipe or hose there I could see.

[Richard]

Stick a rod through the hole and see where it comes out.

[Wanderman]

I already know where it comes out. It's just a 2 1/4" hole in the floor of the closet where the washer dryer is. I can see it in the bay. It had to be connected to something... There's not even a grating over it!

Odd.

[Wanderman]

So can someone look in their Aquahot or whatever bay is below your washer dryer and tell me if there is a hole with any plumbing attached???

Thanks!

[hbens]

Rick,

I need to take my washer/dryer out for repairs but I don't expect to do that for a few months. I did look for the drain in the bay but could not see where it went to. The nice chrome water manifold and doors are in the way.

[Wanderman]

hbens,
My coach is weirdly backwards. The washer dryer closet is curbside so it's above the aquahot

[Richard]

My washer / dryer is above the tag wheel well. I do not recall seeing an obvious drain.

I am guessing here, but since the drain is above the Aquahot/Wet bay, then water will drain out of those bays through the floor plugs.

[Wanderman]

Hmm... But only if I leave the plug out. I am thinking it had a drain into the waste tank at some point.. but not obviously so.

It really appears to be for some kind of overflow condition or a rupture in a washer waterline maybe. To drain the base of the closet if needed.