Posts: 5,751
Threads: 493
Joined: Jul 2012
i may stand corrected. here is the description of that valve
i will have to go out and actually see how mine is hooked up.
tom
RAP6354 Air Solenoid Valve -CHECK LEAD TIME-
Product ordered in new from the manufacturer, please call for in stock availability on rush orders as lead-time can be 2-5 days before it ships.
Air Solenoid Valve
12 Volt | Packard and Ring | Normally Open
Abbreviated Description: “VLV SOL A 12V/NO/PKD&RNG"
tom
2002 45'8" Newell Coach 608 Series 60 DDEC4/Allison World 6 Speed HD4000MH
Posts: 65
Threads: 10
Joined: Mar 2015
Mark & Beverly Fincke
99 Newell Show Coach, # 527 (Heavy Metal)
Twin Slides, Rear Bath
08 Saturn Vue XR SUV Toad
99 Escalade ESV.
Posts: 106
Threads: 13
Joined: Mar 2019
The solenoid is normally open and closes when the compressor turns on and opens to release the pressure and drain the bowl when the compressor turns off.
Ron & Jennifer Ward
2003 Newell Show Coach #643 (Racer Bus) Triple Slide, DD 60
Visalia, CA
Posts: 2,348
Threads: 386
Joined: Jul 2012
For you electrical gurus, can this valve replace the HWH spitter valve that Newell used????
https://www.amazon.com/SNS-2WK025-N08-El...59LP&psc=1
Steve Bare
1999 Newell 2 slide #531
Posts: 2,695
Threads: 228
Joined: Jul 2012
Working pressure on that valve is 100 psi so it would be better to find one with a higher pressure rating. Other than that it should work.
Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
PO 1999 Foretravel 36'
1998 Newell 45' #486
1993 Newell 39' #337
Posts: 2,348
Threads: 386
Joined: Jul 2012
I know that it is slightly below my 110V compressor pressure, but might be an alternative to try. I don't find a normally open valve with 1/4" npt that is rated higher.
Steve Bare
1999 Newell 2 slide #531
Posts: 5,412
Threads: 255
Joined: Jul 2012
There is an alternative and more cost effective solution. Use a standard air compressor controller with pressure relief. Plumb the relief line to the bottom of the spitter eliminating the solenoid valve. The controller will take the place of the well pump switch.
https://www.amazon.com/Compressor-Pressu...PUKC&psc=1
Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home
)
(This post was last modified: 07-20-2021, 09:56 AM by
Richard.)
Posts: 65
Threads: 10
Joined: Mar 2015
Steve,
check out my 110v air compressor layout in the above reply.
You can see the pressure switch from Grainger's that will release the air so the compressor can easily start.
Mark
Mark & Beverly Fincke
99 Newell Show Coach, # 527 (Heavy Metal)
Twin Slides, Rear Bath
08 Saturn Vue XR SUV Toad
99 Escalade ESV.
Posts: 2,348
Threads: 386
Joined: Jul 2012
I replaced my spitter valve with the one from Amazon below. It took getting some reducer adapters as the old one is 1/8" npt. The new one is 1/4" npt. It worked great. Will see if it lasts any better than the original ones. In fourteen years I have replaced the valve 3 times. $21 compared to $150.
https://www.amazon.com/SNS-2WK025-N08-El...59LP&psc=1
Steve Bare
1999 Newell 2 slide #531
(This post was last modified: 11-28-2023, 05:54 AM by
rheavn.)
Posts: 1,695
Threads: 123
Joined: Aug 2012
I used the same switch as Richard shows above. I noticed that after a few months it would begin to bleed off air before it tripped off. I remedied that by slightly bending the tab that contacts the needle of the unloader valve.
1993 Newell (316) 45' 8V92,towing an Imperial open trailer or RnR custom built enclosed trailer. FMCA#232958 '67 Airstream Overlander 27' '67GTO,'76TransAm,'52Chevy panel, 2000 Corvette "Lingenfelter"modified, '23 Grand Cherokee.
(This post was last modified: 11-27-2023, 10:44 PM by
HoosierDaddy.)