My "shore line" warning light on my dashboard was burnt out. It is not a bulb I have seen before. It twists into a mounting block. It has a marking of "IDI 4133". Any one dealt with this type of bulb before & have a source?
Thanks...........................
Steve Bare
1999 Newell 2 slide #531
(This post was last modified: 11-19-2012, 12:55 PM by rheavn.)
Got to looking closer & the bulb part pulled out of the black part that twists into the holder. Still not sure where to get the bulb. The back part is just the holder, so the IDI 4133 marking is not for the bulb.
Steve Bare
1999 Newell 2 slide #531
(This post was last modified: 11-19-2012, 01:09 PM by rheavn.)
You can get those at auto zone but I really like the idea of LEDs. I think about half of mine were either burned out or have since had to be replaced. ...and... I hate that mounting arrangement. It takes forever to get those little suckers back in!
Bill Johnson
Birmingham, Alabama
(This post was last modified: 11-20-2012, 06:53 AM by bikestuff.)
Looks like a bulb I had in an old Mercedes. Yeah try an auto parts.
Steve & Patti, Bonnie and Tucker
1982 Newell 38' Classic, DD 6V92
cocktails for as many will fit in the site, dinner for as many can sit at the pick-nick table and sleeps 2 since I fixed the couch
(This post was last modified: 11-20-2012, 07:07 AM by prairieschooner.)
Thanks to all! I'll try an auto parts and let every one know if they have them. Obviously Bill you have replaced some because they are very difficult to get back in with my fat fingers.
Finished checking all the warning lights. I had three burnt out. When putting them back in I had trouble twisting the holder to lock them in. I have a very small Crescent wrench that I could adjust to fit the square back of the light holder and easily twist it into place.
