11-13-2018, 03:27 PM
I knew you would come up with an elegant solution Tom.
installing magnum 2812 questions
11-15-2018, 06:18 PM
i finished my mount for the inverter. to provide a heatsink/heat barrier i used 1/8" aluminum diamondplate. you can see i used 1/4" t nuts for the 8 mounting bolts for the inverter. then i drilled the diamondplate to match the mounting holes. 4 of the mounting bolts were put on and the inverter lifted up and over the bolts and then slid to latch. then the other 4 bolts put in.
the wall in the bay is only half inch plywood, so i used 16 screws to mount the plywood to the wall before i put the diamondplate on.
all is solid and worked well other than that is one heavy unit to lift up laying on your side in the bay....ha
i will finish hooking it up over the next couple of days. i have yet to make the mounting plate adapter for the control panel over the drivers seat.
tom
the wall in the bay is only half inch plywood, so i used 16 screws to mount the plywood to the wall before i put the diamondplate on.
all is solid and worked well other than that is one heavy unit to lift up laying on your side in the bay....ha
i will finish hooking it up over the next couple of days. i have yet to make the mounting plate adapter for the control panel over the drivers seat.
tom
2002 45'8" Newell Coach 608 Series 60 DDEC4/Allison World 6 Speed HD4000MH
11-20-2018, 02:13 PM
finished the inverter charger install today. and got it all working. just have a little wire management left to do but that will only take a little while.
tom
tom
2002 45'8" Newell Coach 608 Series 60 DDEC4/Allison World 6 Speed HD4000MH
« Next Oldest | Next Newest »
Users browsing this thread: 2 Guest(s)