[lbrachfe]

Thanks Steve,, I will pick some up just in case my newest seal job doesn't hold. I also finally spoke with Girard and found the problem and do feel dumb I didn't think of this.
First, I needed to return the awning to the full out position in line with where I replaced the fabrics. Then use the bottom limiter control and turn it towards negative and each full turn equals 1" and continue until at the open position desired. That's it....
For the letting out you use the top limiter from the closed position the same way. Limiter switch won't adjust unless the awning is in the previously stopped position to start the adjustment...