[hypoxia]

JK 

I adjusted the Noshok 300L to about 170psi.  There is a switch function adjustment on the top of the 300L.  No particular reason for that pressure, I just got tired of pressurizing, depressurizing & adjusting it and 170 seemed reasonable.  I did not adjust hysteresis.  I have the DIN electrical plug.

[quote pid="67309" dateline="1732467904"]
I was going to install a valve prior to the sensor to isolate it if necessary. 
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi. 
JK 

[/quote]

[quote pid="67309" dateline="1732467904"]
I was going to install a valve prior to the sensor to isolate it if necessary. 
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi. 
JK 

[/quote]

[quote pid="67309" dateline="1732467904"]
I was going to install a valve prior to the sensor to isolate it if necessary. 
Since I have adjusted my RAS system pressure to the ZF recommended values I need to install a pressure sensor with a lower trigger value. I’ll probably use 200-210 psi. 
JK 

[/quote]