08-20-2024, 10:58 AM
Steve,
My floor wouldn't raise up after the salon slide went out. I worked with a tech at HWH via phone and emails. I was set to go to HWH for repair when my salon seal rolled out when I brought the slide in. I went to Newell to get that and other stuff repaired instead.
What I ended up doing was put a rocker switch w/fuse between 12 volts and the FLOOR UP solenoid. After the slide goes out I toggle the switch and the floor comes up with the EXTEND button. Then I go back out and turn that switch off.
Eventually I'll put rocker switches in the cabinet and be able to do this all manually from inside.
When you say "The lights on the unit don't all work" do you mean the status box in the L1 bay? My status lights all work but something wasn't telling the main control board to activate the up solenoid.
My floor wouldn't raise up after the salon slide went out. I worked with a tech at HWH via phone and emails. I was set to go to HWH for repair when my salon seal rolled out when I brought the slide in. I went to Newell to get that and other stuff repaired instead.
What I ended up doing was put a rocker switch w/fuse between 12 volts and the FLOOR UP solenoid. After the slide goes out I toggle the switch and the floor comes up with the EXTEND button. Then I go back out and turn that switch off.
Eventually I'll put rocker switches in the cabinet and be able to do this all manually from inside.
When you say "The lights on the unit don't all work" do you mean the status box in the L1 bay? My status lights all work but something wasn't telling the main control board to activate the up solenoid.
Hank & Natalie Bensley
2001 Double Slide #586.
2021 Cherokee Trailhawk Toad
Port Orange, FL. Upcoming Snowbirds in Endwell, NY
