[WillieG]

Last fall I had a major air leak in my front right air hose and had a new one installed at a shop(not the one that did my tag bushings wheel seals and bearing alignment)  So today took it for a ride went through a tight round about near my house and heard a pop clunk in my front right,thought what was that. Drive up interstate about 8mes then back to storage as rain was coming. I did notice stopping on exit ramp pressure dropped to 90psi then while parking in the garage while using a lot of break maneuvering in pressure dropping like crazy and could hear a lot of air. Aired it back up shoot off had my son step on break while I looked under and the fitting at the break chamber was snapped off and also they used Teflon tape on it.In Richards YouTube he said that’s not a good idea. My question is what would cause this hose to bust off?  Too short or over tightened?  If zoom in where the rubber meets the brass it looks messed up too