[pairodice]

Yep you are correct Richard we managed to weld it on without taking into consideration the outside pin hole so it did not line up - it was close enough to not make a hole but it was not happy and I stopped it when Karen started screaming lol. Now I’m here cutting it off again and will try to reweld it on tomorrow. What is odd is that the same hydraulic hoses that used to fit now are too short to go where they are supposed to fit not sure how tight these are supposed to be. Also I’m rebuilding the HWH block/pins tomorrow when the orings arrive from McMaster Carr. Of course now that I have taken my sweet time to get it all apart my Mom and Dad have both went in the hospital - we had planned on visiting in two weeks but may be pushing that timeline up and having to use big pins to hold the slide room in…