[Gnawrocki1]

Let me try again. I see it is not aligned with the outside pin hole. Is it aligned with the inside pin hole?

Because if it is, you have a bigger problem. The room is supposed to go in and out square with the coach. If you reposition to align with the outside hole, you are going to punch a new hole when the slide goes out.

Compressed air in the cans is often flammable.

Richard, it seems like the welded the position of not only the bracket that holds the actuator, but also the pin hole steel piece, and it seems like it was welded in a different axial position.  

The actuator seems to be located to far to the front (right) based on where the shadow of the previous location used to be and that is why it does not line up in the closed position.  

Good measurements will need to be taken from the original location and welded there or you will run in to issues when your slide is retracted.....so it seems