[pairodice]

Just now (finally) getting back to this. Had the slide pin mechanism in the front salon slide re-welded this week after it had bent from years of use. This was not something I would want to have to do without the slide room being torn apart (still)… When I went to rehang the HWH slide pin hydraulic mechanism (doohickey?) I pulled the hydraulic hoses to stretch them to the location where the bracket was but they are about 2 inches short… not sure how tight these lines are supposed to be. Is there a 2” extension piece of some type that I could use to make up the distance that would take all the hydraulic pressure exerted on these lines? I think they shrunk in the last 2 years sitting in the shop… :-(