12-12-2023, 09:59 AM
Jeff,
On 653 there were circuit cards installed in a rack in the basement. On one of the cards there were fuses (along with spares) for each of the motors. (You had to remove the card to see the fuses).
653 was an early Valid slide coach, so they may have changed the setup in the first couple…but I would look at the slide controller and see if you can find fuses on the controller.
Be sure to power down the PLC before pulling cards.
Bill
PS. I just re-read the earlier posts and they show where the fuses are located. If you are looking for a source to buy the fuses, I would try Napa.
On 653 there were circuit cards installed in a rack in the basement. On one of the cards there were fuses (along with spares) for each of the motors. (You had to remove the card to see the fuses).
653 was an early Valid slide coach, so they may have changed the setup in the first couple…but I would look at the slide controller and see if you can find fuses on the controller.
Be sure to power down the PLC before pulling cards.
Bill
PS. I just re-read the earlier posts and they show where the fuses are located. If you are looking for a source to buy the fuses, I would try Napa.
Bill Johnson
Birmingham, Alabama