[Tfrazier]

Me again,

Started messing around with the Ride Height Control. I read a lot of the posts about this topic before I got started and it seemed pretty straight forward. First thing I did was take the air down and then let it build up to travel height. Then measured the height of the 1" square tube in front of the rear drive axel. 

This where I am stuck. The left side (high side) measures 12 3/4" and the right side (low side) measures 13". Does this make sense? Both are quite a bit higher than the 11-11 1/2" that Michael pointed out. 

 I also measured distance from the center edge of the fender to the ground. Left side (high side) was 43.5 and the right side (low side) was 42 3/4.

Would it make sense to take the same measurements over the next several days to see if the right side drops further?

Thanks