[mycbarnes]

Yes, after reading the history on the condenser motors I plan to replace all three. One has a knocking noise as an early warning. If I could find new condenser coils I would replace mine that have been patched. I should post pictures of where they rubbed holes in the pass thru area of copper tube on end galvanized support structure. It’s from vibration and I bet common to every unit. Two of mine were repaired by solder before I bought coach. Then I have had to redo them once, which only just blew again from thin wall in repair area. This time I have cut out the bad and put in a copper elbow. Who ever repaired them before me did a hatchet job and it’s come back to haunt me at 108 degrees , high head pressures and copper lines too thin  wall to safely braze. Silver solder can withstand the pressure, but who ever fixed the area before me must of sanded them to bright copper enough to make the line super thin wall. So, this time, I just cut out the bad. I’ll look for pictures.