You are not logged in or registered. Please login or register to use the full functionality of this board...


Fitting Leak Hydraulic Cooler (In front of Drive axle)
#1

I'm sitting in Bay 7 at the Newell factory, waiting for some finishing fiberglass work. Decided to run the washer/dryer for a test. While looking underneath for water leaks I see about 2-3 gallons of ATF on the floor, leaking from where the techs found a leak and repaired it.

The factory is closed on Fridays (pretty much) so i called the emergency number and spoke to Jim, he is trying to find someone to come out and figure out what's wrong.

Seems pretty ironic to get stuck at the factory after a week of work!

Stay Tuned

Be seeing you,

Rick Miller
#423
1996, 45'+, Non-slide, Series 60, ABS, 1.5 Bath, Reverse Floorplan


Reply


Messages In This Thread
Fitting Leak Hydraulic Cooler (In front of Drive axle) - by Wanderman - 03-24-2023, 07:18 AM
RE: Fitting Leak Hydraulic Cooler (In front of Drive axle) - by Wanderman - 03-24-2023, 07:37 AM
RE: Fitting Leak Hydraulic Cooler (In front of Drive axle) - by bikestuff - 03-24-2023, 09:41 AM
RE: Fitting Leak Hydraulic Cooler (In front of Drive axle) - by Wanderman - 03-24-2023, 10:59 AM
RE: Fitting Leak Hydraulic Cooler (In front of Drive axle) - by Jack Houpe - 03-25-2023, 04:40 AM
RE: Fitting Leak Hydraulic Cooler (In front of Drive axle) - by ccjohnson - 03-25-2023, 11:28 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)