12-21-2022, 02:14 PM
Wires were torn from the vibrate motor in the seat bottom, I suspect a tech was encountering resistance in lifting the seat and gave a good jerk. Actually I think I just described him 
No need to unplug when it's quicker to rip them out.
Busy installing a 10HP compressor pump on a new tank in my shop after the old tank started leaking. I now have a spare 10 HP pump and a 10 HP 3 phase motor if anyone needs one. Life without pneumatics is nearly impossible. I tried out a two stage single cylinder pump but it couldn't keep up with my bead blaster so I'm putting my old 2 cylinder V pump on. It is much smoother than the single.
No need to unplug when it's quicker to rip them out.Busy installing a 10HP compressor pump on a new tank in my shop after the old tank started leaking. I now have a spare 10 HP pump and a 10 HP 3 phase motor if anyone needs one. Life without pneumatics is nearly impossible. I tried out a two stage single cylinder pump but it couldn't keep up with my bead blaster so I'm putting my old 2 cylinder V pump on. It is much smoother than the single.
Jim
2014 Newell Coach 1482 Mid Entry 45'8" Valid Slides and Valid Levelling