11-17-2022, 07:40 AM
Three questions:
1) How much time would you set aside to do this job from start to finish on one side?
2) Is there more than one jacking point?
3) exactly where is(are) the jacking point(s)? - The pic earlier in the thread is a good indication, but I'd like to be certain.
Thanks.
1) How much time would you set aside to do this job from start to finish on one side?
2) Is there more than one jacking point?
3) exactly where is(are) the jacking point(s)? - The pic earlier in the thread is a good indication, but I'd like to be certain.
Thanks.
David
2004 Newell #695
Series 60
Quad slide front entry