[dbld58]

Each time I have a problem I need to push the spindle up inside the body. Often I need a hammer. The part with the fat o-ring keeps getting stuck in the head and won't raise with the air pressure. I don't see how air leakage could cause that. There's no air in the top section, just water. The spindle needs to raise to let the water through and this is not happening.

FYI - I have that second in-line regulator installed with a gauge on it and it is holding steady at about 28 psi for the last several hours.

This thing is kicking my butt in several ways. Now it won't start even though I am plugged into 50 amp...is there an emoji for head exploding?