06-30-2022, 07:03 AM
Richard,
I will test the Y1 output from the tstat today, but sending 12V to the Y1 wire leading down to the new board starts the compressor without a problem. I waited MANY more than five minutes as well.
I don't recall whether, when set to AUTO, the circulation fan starts immediately and then after the delay the compressor kicks in. I am also unsure whether there are 2 fans On fore the condenser and one for the circulation since the board only has the 3 connector one for the circulation fan and the compressor connector. Only other external wiring is power in and the tstat.
At least i have cold air and "normal AC amp loads all around.
Rick
I will test the Y1 output from the tstat today, but sending 12V to the Y1 wire leading down to the new board starts the compressor without a problem. I waited MANY more than five minutes as well.
I don't recall whether, when set to AUTO, the circulation fan starts immediately and then after the delay the compressor kicks in. I am also unsure whether there are 2 fans On fore the condenser and one for the circulation since the board only has the 3 connector one for the circulation fan and the compressor connector. Only other external wiring is power in and the tstat.
At least i have cold air and "normal AC amp loads all around.
Rick
Be seeing you,
Rick Miller
#423
1996, 45'+, Non-slide, Series 60, ABS, 1.5 Bath, Reverse Floorplan