03-24-2022, 04:14 AM
For posterity, I am going to include the part number for the burned connector I had to replace on the HWH board. Richard Entrekin was able to find this for me... I would have never found it, thanks Richard!
If you look in the earlier picture, there is an orange connector I'm holding. It is a pass-thru connector (the wire enters and keeps going, without being cut). I think there are also similar connectors used elsewhere on these HWH boards, some probably 2 or 3 pin. But with the information here on this 4-pin, you could probably also locate ones with a different number of pins. Also, my original connector had a cap on it. I was not able to find this part number, but as the cap was ok, I re-used it on the new connector.
I will include manufacturer information as well as mouser.com link and #.
1. Manufacturer is TE Connectivity
2. Manufacturer part number: 3-643817-4
3. Mouser # 571-3-643817-4
4. Link https://www.mouser.com/ProductDetail/TE-...kUZA%3D%3D
Alan
If you look in the earlier picture, there is an orange connector I'm holding. It is a pass-thru connector (the wire enters and keeps going, without being cut). I think there are also similar connectors used elsewhere on these HWH boards, some probably 2 or 3 pin. But with the information here on this 4-pin, you could probably also locate ones with a different number of pins. Also, my original connector had a cap on it. I was not able to find this part number, but as the cap was ok, I re-used it on the new connector.
I will include manufacturer information as well as mouser.com link and #.
1. Manufacturer is TE Connectivity
2. Manufacturer part number: 3-643817-4
3. Mouser # 571-3-643817-4
4. Link https://www.mouser.com/ProductDetail/TE-...kUZA%3D%3D
Alan
Alan Johnson
Dallas Tx
Newell #485
1998 2 slides