01-17-2022, 02:47 PM
https://www.beckettcorp.com/wp-content/u...ctions.pdf
Section 13 and 14 tells you what to do with the wiring.
Diagnose your existing coil by simply removing it, and hooking leads to a 12V source, it should continuously spark.
The Beckett igniter is designed to be mounted directly on the side of a furnace. Obviously we are not using it that way. That is why there is reference earlier in the thread about the use of “spark plug wire”. You have to make two high voltage wires to go from wherever you mount the igniter to the spark terminals inside the Webasto.
Section 13 and 14 tells you what to do with the wiring.
Diagnose your existing coil by simply removing it, and hooking leads to a 12V source, it should continuously spark.
The Beckett igniter is designed to be mounted directly on the side of a furnace. Obviously we are not using it that way. That is why there is reference earlier in the thread about the use of “spark plug wire”. You have to make two high voltage wires to go from wherever you mount the igniter to the spark terminals inside the Webasto.
Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home
)