01-17-2022, 02:14 PM
Quick question. Would it be possible to replace JUST the Webasto ignition coil with the Beckett Powerlight 12V one? I am not sure why it WOULDN'T work but I figured I'd ask first. I have been getting intermittent ignition lately and could use that as a diagnostic tool as well as getting ready to do the Beckett mod.
Between the Webasto coil and the Webasto DBW2010 controller it's an amazing cost savings AND much easier to source the parts.
Also, It's not completely clear how to connect the HV terminals of the igniter to the terminals. I know which wire to use... but How? And I see only 3 wires covered in the schematic for it. W and B/W and then another W to the IGNITER and GND terminals. What about the other wires? Unused??
Lastly which sub-model of Beckett 7556 is used?
Thanks!
Between the Webasto coil and the Webasto DBW2010 controller it's an amazing cost savings AND much easier to source the parts.
Also, It's not completely clear how to connect the HV terminals of the igniter to the terminals. I know which wire to use... but How? And I see only 3 wires covered in the schematic for it. W and B/W and then another W to the IGNITER and GND terminals. What about the other wires? Unused??
Lastly which sub-model of Beckett 7556 is used?
Thanks!
Be seeing you,
Rick Miller
#423
1996, 45'+, Non-slide, Series 60, ABS, 1.5 Bath, Reverse Floorplan