[TMCopeland]

The initial part of the plumbing system is the water inlet and associated hose reel.  My Glendenning reel stopped working and I have been trying to figure the source of the problem.  The circuit breaker on the switch was inoperative, impossible to reset, so I began to take the switch apart.  Long story short, I found that the hot side wasn’t hot, so there should be a fuse somewhere.  The manual calls for a 10 amp fuse in line on the hot side in spite of the circuit breaker being identified as 4 amps.  Anyway I have searched high and low on my fuse panels and can’t find the location of the associated fuse. I did find an unlabeled 7.5 amp fuse that had blown and replaced that but still no joy.  Called Newell and they weren’t able to help either.  I will try them again on Monday.

Does anyone have any idea where the fuse for the hose reel might be located? And also but less important, does anyone have any idea what circuit might require the 7.5 amp fuse?

Any input appreciated!

Terry
Currently in Santa Fe and headed for Pagosa Springs later this week.