11-10-2020, 07:32 AM
I’m installing a new product from Aquor Water System in the water bays. My first change is in the curb side AquaHot/Waste dump bay that also has a water tank fill port.
I’m replacing this fitting.
This is the new fitting.
I used a knockout tool used in electrical work to enlarge the hole where the new valve mounts. I also drilled three new holes for mounting screws.
The rest of the install is straight forward.
No more messing around with the traditional hose ends.
I plan on replacing the fittings on the driver side water bay and modify my “City Water” inlet connector.
I’m also adding valves that will be used to rinse out the waste tank and ThetFord Macerator.
Check the system out at:
aquorwatersystem.com
Take care,
JK
I’m replacing this fitting.
This is the new fitting.
I used a knockout tool used in electrical work to enlarge the hole where the new valve mounts. I also drilled three new holes for mounting screws.
The rest of the install is straight forward.
No more messing around with the traditional hose ends.
I plan on replacing the fittings on the driver side water bay and modify my “City Water” inlet connector.
I’m also adding valves that will be used to rinse out the waste tank and ThetFord Macerator.
Check the system out at:
aquorwatersystem.com
Take care,
JK
Kristi & Jeff King
Bentonville, Arkansas
#744 2005 45’ Newell Coach
ZF Suspension/Active Steering Tag Axle
CAT-13 ACERT KCB Engine 525HP 1642 ftlbs Torque Cat Compound Turbocharger 43.5 psi
Allison HD4000MH Transmission with PTO drive.