08-17-2020, 04:54 AM
Welcome to the forum!!!!!
Your post is a little confusing. None of your slides move now? If so, I would suspect that the slide motor has gone bad. Motor sits below the solenoids in the left front bay. With a volt meter verify that 12V are going to and from the solenoid, with the ignition on and slide switch depressed. Then follow the large battery type cable to the motor and verify 12V is reaching the motor--ignition on & slide switch depressed. With the ignition on and slide switch depressed you can hear the motor if it is working.
Simple and inexpensive fix. Two bolts and the battery cable hold the motor on and can be removed without losing fluid.
Elreg sells the motor. https://www.elreg.com/products/dc-motors/
Your post is a little confusing. None of your slides move now? If so, I would suspect that the slide motor has gone bad. Motor sits below the solenoids in the left front bay. With a volt meter verify that 12V are going to and from the solenoid, with the ignition on and slide switch depressed. Then follow the large battery type cable to the motor and verify 12V is reaching the motor--ignition on & slide switch depressed. With the ignition on and slide switch depressed you can hear the motor if it is working.
Simple and inexpensive fix. Two bolts and the battery cable hold the motor on and can be removed without losing fluid.
Elreg sells the motor. https://www.elreg.com/products/dc-motors/
Steve Bare
1999 Newell 2 slide #531