[pairodice]

The molding piece right behind the driver door was coming loose so I unscrewed the little screw holding it in place.  The molding was very loose and I noticed that several of the large pop-rivets that hold the molding on were sheared.  I slid the molding off since I didn’t want it falling off going down the road.  So now I’m to the point of wanting to put the molding back on and am in a quandary.  I called Newell and they said i would need to remove the engine bay cover at the rear of the coach and slide the LONG piece of molding out and then put the the other in.  Well this made sense until I tried it.  Seems there is an aluminum trim/stop in the end of the short molding that makes it impossible to push over the plastic clips that hold the molding on.  Any ideas?  Do I have to remove the main cabin door to get the piece to go on?