[dreemail]

Hi Chester / Richard.  I have the same AC Circuit board (305-2547 REV A) and two compressors.  I appreciate all the diagrams and photos you have provided too.  Thank you.  

My question is coming the day I tried to wire this up for a test.  

The A1 A2 wires required that I cut the original wire and then connected these directly from the circuit board to the A1 and A2 sides (and Low Voltage) on the Eaton Relay (C25ANB125A).  
[Q1]: What do I do with the original wires that I cut?  Are they no longer used?  Or spliced into and remain?

The L1/L1 (120V) Is also confusing to me. The color diagram shows the the 120V wires are clearly connected to the Top and Bottom on the Eaton relay.  But then there is a little green and little black (top of digram) connecting back to the circuit board.  And the same at the bottom of the diagram except they are little green add little red. 
[Q2]: is this an actual spliced connection?  I assume that it is looking at your diagram (shows photos of he Eaton Relay) and other Finke labled diagram (Schematic).

Im not sure when you will get this or respond, but I find writing it out helps me work through the problem.