02-08-2013, 08:33 PM
Guys,
I understood these steps have torque sensing motors. If that is correct, why don't they stop or reverse when they hit something.
When I worked on mine some time ago, I was trying to figure out what controlled it stoping in the open/closed position. I was told it was torque sensing, & that when the motor drew over a certain amperage it either stopped or reversed.
I understood these steps have torque sensing motors. If that is correct, why don't they stop or reverse when they hit something.
When I worked on mine some time ago, I was trying to figure out what controlled it stoping in the open/closed position. I was told it was torque sensing, & that when the motor drew over a certain amperage it either stopped or reversed.
Gordon
1991 41.5' #266
8V92 DDEC II