09-24-2018, 05:01 PM
Ron,
Obviously a lot went on offline.
Did you hotwire the rear solenoids because they were not getting a signal?
Could you raise the rear in Level mode?
Were both sides relatively equal? If they were that sort of indicates a low pressure problem, since the likelihood of a failure happening on both sides at the same time is pretty low. The front will raise with about 90 psi but the back takes about 120
Obviously a lot went on offline.
Did you hotwire the rear solenoids because they were not getting a signal?
Could you raise the rear in Level mode?
Were both sides relatively equal? If they were that sort of indicates a low pressure problem, since the likelihood of a failure happening on both sides at the same time is pretty low. The front will raise with about 90 psi but the back takes about 120
Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home
)