06-20-2018, 03:44 PM
Side questions:
1. The 11A - 12A for the compressor -- is that on the mains input that comes into the board on top or bottom (ie compressor + evap blower + condenser blower)? Or do I need to get just the compressor wire out of the bundle?
2. One thing that's always been annoying: If I switch the thermostat to Off, then both the heat and cool setpoints get reset to ridiculous values. Is that normal?
1. The 11A - 12A for the compressor -- is that on the mains input that comes into the board on top or bottom (ie compressor + evap blower + condenser blower)? Or do I need to get just the compressor wire out of the bundle?
2. One thing that's always been annoying: If I switch the thermostat to Off, then both the heat and cool setpoints get reset to ridiculous values. Is that normal?
Paul
Coach #540
2000 Double Slide, Bath and a half, Average sized fan for its age
Fulltiming for a while around CO