12-30-2012, 04:37 PM
Tom,
On the bottom side of my plastic dash cover there were approximately 1" round holes with a 1/2" long slot off one side. The head of the retainer is bigger than the holes but I was able to easily work them between the foam rubber and the plastic cover. The ultraleather is put on over the foam on my cover. I then pushed them sideways into the slot and they "snapped" in like they were designed. Is your dash cover not like that? Let me know if you want a photo.
"No two Newells are the same"
On the bottom side of my plastic dash cover there were approximately 1" round holes with a 1/2" long slot off one side. The head of the retainer is bigger than the holes but I was able to easily work them between the foam rubber and the plastic cover. The ultraleather is put on over the foam on my cover. I then pushed them sideways into the slot and they "snapped" in like they were designed. Is your dash cover not like that? Let me know if you want a photo.
"No two Newells are the same"
Steve Bare
1999 Newell 2 slide #531