[rwg200]

On my coach (with valid slides) there are fuses in the programmable logic controller (PLC).  It is the computer looking thing in the basement. If I remember correctly,  My fuses were located on a board that had to be removed from PLC to access them.

When I had bad bearing, I stayed on switch too long and blew a fuse... actually several before I figured it out.   I would check fuses with ohmmeter to be sure.

Also, I have never heard of a motor going out.  It sounds like power problem to me.

Thanks for the advise, i will make a call!

---

On my coach (with valid slides) there are fuses in the programmable logic controller (PLC).  It is the computer looking thing in the basement. If I remember correctly,  My fuses were located on a board that had to be removed from PLC to access them.

When I had bad bearing, I stayed on switch too long and blew a fuse... actually several before I figured it out.   I would check fuses with ohmmeter to be sure.

Also, I have never heard of a motor going out.  It sounds like power problem to me.

Thanks, that i think is my problem, the slide has been juddering slightly as if a bearing may be failing, on this occasion though it juddered very badly and i released the button and now there is no life from the motor,
I have found the slide control computer in the basement which seems to have 4 amp glass fuses for the slide and also for the floor, i have checked them and they seem ok, i need to confirm this with a multi meter,
Guess if they are ok its a call to Newell to see if there is a override procedure!
Thanks for the advise though,