12-20-2012, 03:53 AM
Les
Look for a tap wrench. The long handle style, not the tee handle. They are made to fit the square shank on the ez out. If the person who put the fitting in used a Loctite product to get it to seal, then you will have to use a little heat to get it to turn loose. Easy does it.
I would use heat before I started drilling on the fitting. If you drill you are going to get particles that could cause major problems.
If you have to take it out, which is what I would do, number the air lines, put a matching number on the brake body, take plenty of pictures, and yank it out. While I had it out I would Tom it and replace all the fittings with new ones.
Call me 817 223 2056
Look for a tap wrench. The long handle style, not the tee handle. They are made to fit the square shank on the ez out. If the person who put the fitting in used a Loctite product to get it to seal, then you will have to use a little heat to get it to turn loose. Easy does it.
I would use heat before I started drilling on the fitting. If you drill you are going to get particles that could cause major problems.
If you have to take it out, which is what I would do, number the air lines, put a matching number on the brake body, take plenty of pictures, and yank it out. While I had it out I would Tom it and replace all the fittings with new ones.
Call me 817 223 2056
Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home
)