12-19-2012, 11:43 AM
Here are the photos of the broken brass fitting nut.
I am putting good over 100lbs of pressure on the wrench but bit wont turn , it twist some but wont turn? I hope those treads on the cilinder are not cuntercloackwise ?
I am putting good over 100lbs of pressure on the wrench but bit wont turn , it twist some but wont turn? I hope those treads on the cilinder are not cuntercloackwise ?
Les & Cheryl Korcala
Fulltime on the road hub base in Montana
Newell 2001 2 slide #582
security system 2 Rhodesians Ridgebacks (Basha & M'Kala)
Nissan Exterra 2007
Co-Motion "Robusta" tandem
Trek "madone" road bikes
Trek 5.8 MTb