12-18-2012, 07:06 PM
Thanks Ron & Forest,
I went to store and got easy out tool set and used right size in the hole, toped lightly and used wrench on it.
Is very hard sitting in there! looks like some sort of sealer arond the tread, I tried with quite bit force with long laverage monkey wrench , it won't get free ?
Was wonder if I could use heat on it? perhaps some lube to loose the treads.
I am surprise to see that brass union be so tight !
I went to store and got easy out tool set and used right size in the hole, toped lightly and used wrench on it.
Is very hard sitting in there! looks like some sort of sealer arond the tread, I tried with quite bit force with long laverage monkey wrench , it won't get free ?
Was wonder if I could use heat on it? perhaps some lube to loose the treads.
I am surprise to see that brass union be so tight !
Les & Cheryl Korcala
Fulltime on the road hub base in Montana
Newell 2001 2 slide #582
security system 2 Rhodesians Ridgebacks (Basha & M'Kala)
Nissan Exterra 2007
Co-Motion "Robusta" tandem
Trek "madone" road bikes
Trek 5.8 MTb