07-07-2016, 06:36 PM
All i found in mine was dirt. I can see where a 3/4 tall bushing might be a good idea. I will see what I can find that fits inside there.
Today I installed the new 12v compressor with a check valve on exhaust . No more laeaks there. Also repiped with compression fittings the 110v Thomas compressor and upgraded to 3/8 od air line instead of 1/4. Installed a new check valve and water separator with new electric drain valve. No more leaks there either.
Now the air comes up faster with the 110v system and after shutdown it holds pressure quite well. It restarted at 80 psi about 1.5 hrs later, ran for 2.5 minutes, built it back to 100 psi and held good for another 2 hrs when it cycled again. With no head pressure the compressor started very easy and functions well.
Ordered 6 new 8D AGM batteries, Magnum Ms2812 Inverter , ARC50 remote, AGSN gen autostart module and slideout awning from ZipDee
A good day......expensive but getting it sorted out.....
Today I installed the new 12v compressor with a check valve on exhaust . No more laeaks there. Also repiped with compression fittings the 110v Thomas compressor and upgraded to 3/8 od air line instead of 1/4. Installed a new check valve and water separator with new electric drain valve. No more leaks there either.
Now the air comes up faster with the 110v system and after shutdown it holds pressure quite well. It restarted at 80 psi about 1.5 hrs later, ran for 2.5 minutes, built it back to 100 psi and held good for another 2 hrs when it cycled again. With no head pressure the compressor started very easy and functions well.
Ordered 6 new 8D AGM batteries, Magnum Ms2812 Inverter , ARC50 remote, AGSN gen autostart module and slideout awning from ZipDee
A good day......expensive but getting it sorted out.....
MG