[les korcala]

Chester, larry , Goron & Steve,

Thanks you for great advise and sugestions.
As Gordon have mentioned thsi hose is short and on angle and i notices as teh images shows that is not fitting all the way in, after pushing & twisting in i was able to seat it in , but again I would never trust thsi to work!

What I did in mean time , I used sealer type silicone and just covered whole area, I did this to test other areas for more laeks!

I will do as Steve sugested and either get new hose with good locking ring or as Gordon sugested just replace last 6" sections of it .
Push type fitting end of the hose with out any locking ring around is not good in my opinion aspecilally where you deal with none flexeble hose as this one is , is just not much bend to it , it feels like had plastic type hose.

Thsi small hose leak made the 110V compressor working double time ( extra 23 mnutes in each cycle )

I do like the Chester idea placement of teh compressor in teh Generator's bay, I have to look in to ist if there is room to perhaps move it! clever idea!

Best,
Les