12-03-2012, 12:35 PM
Tuga,
I hope you have same problem as I ,
I just checked cycle of my air compressor after pushing that blk hose tight to the valve , I noticed it will hold wel but not perfect ( still very some air coiming off that area )
OHm, amazing improvement!!!
57 minutes total time between cycles!! thsi air was steady laeking out very small pin hole area and made the tank loose so much air ! ( 23 minutes !!! )
After spraying well the area i could see large bubbles coming of that hose end's.
Also building air cycle is reduced to 2 minutes of total time from 3-4 minutes!
Now, I have to figure out how to fix thsi problem ! might need new hose or the valve, still not sure if is coming from steel part of plastic hose part of it?
More on thsi later.
Les
I hope you have same problem as I ,
I just checked cycle of my air compressor after pushing that blk hose tight to the valve , I noticed it will hold wel but not perfect ( still very some air coiming off that area )
OHm, amazing improvement!!!
57 minutes total time between cycles!! thsi air was steady laeking out very small pin hole area and made the tank loose so much air ! ( 23 minutes !!! )
After spraying well the area i could see large bubbles coming of that hose end's.
Also building air cycle is reduced to 2 minutes of total time from 3-4 minutes!
Now, I have to figure out how to fix thsi problem ! might need new hose or the valve, still not sure if is coming from steel part of plastic hose part of it?
More on thsi later.
Les
Les & Cheryl Korcala
Fulltime on the road hub base in Montana
Newell 2001 2 slide #582
security system 2 Rhodesians Ridgebacks (Basha & M'Kala)
Nissan Exterra 2007
Co-Motion "Robusta" tandem
Trek "madone" road bikes
Trek 5.8 MTb