05-27-2016, 12:16 PM
Sayed,
That looks like your suspension "six pack" that controls the inflation / deflation of the airbags.
As far as the rust. I have two uneducated thoughts.
1) Where is the water coming from? I had similar issues on my electric reel bay and finally fixed water intrusion by putting eternabond tape on the seam on roof between the metal roof and the fiberglass end cap. I am not positive that this is where the leak was, but it fixed water getting into the bay. (My limited experience is that the source of the water is NOT the door seal. It is probably somewhere else).
2) The paint that Newell uses is grey primer. I suspect that they can tell you the exact color which would save you some time in masking off all the mechanical bits mounted to the wall.
Since that all looks like surface rust, I would not go too overboard with the fix. Some wire brush work should get most if not all the rust off.
Good luck.
bill
That looks like your suspension "six pack" that controls the inflation / deflation of the airbags.
As far as the rust. I have two uneducated thoughts.
1) Where is the water coming from? I had similar issues on my electric reel bay and finally fixed water intrusion by putting eternabond tape on the seam on roof between the metal roof and the fiberglass end cap. I am not positive that this is where the leak was, but it fixed water getting into the bay. (My limited experience is that the source of the water is NOT the door seal. It is probably somewhere else).
2) The paint that Newell uses is grey primer. I suspect that they can tell you the exact color which would save you some time in masking off all the mechanical bits mounted to the wall.
Since that all looks like surface rust, I would not go too overboard with the fix. Some wire brush work should get most if not all the rust off.
Good luck.
bill
Bill Johnson
Birmingham, Alabama