01-14-2016, 06:00 PM
Thanks for the reply!
Then the air line comes over to the air valve for the genset open/close valve? Unfortunately the air line goes behind the heat shielding so I can't just follow it. I figured a regulator would have a gauge for adjusting pressure. Now I'm wondering if the leak is just the regulator lowering the 110 psi pressure from shop air.
Does any one know what pressure the genset air cylinder operates on?
Sure wish Newell provided schematics for this stuff. It would sure save a lot of time & questions.
Then the air line comes over to the air valve for the genset open/close valve? Unfortunately the air line goes behind the heat shielding so I can't just follow it. I figured a regulator would have a gauge for adjusting pressure. Now I'm wondering if the leak is just the regulator lowering the 110 psi pressure from shop air.
Does any one know what pressure the genset air cylinder operates on?
Sure wish Newell provided schematics for this stuff. It would sure save a lot of time & questions.
Steve Bare
1999 Newell 2 slide #531