10-21-2015, 01:32 PM
Gang,
This problem has come back! I have plenty of water and have tried the priming technique that Headhunter suggests. My pump will start, and run for about 12 seconds then go to zero and immediately start again. If I keep the water on, after about 5 minutes of cycling, the pump will go into alarm and turn off. At that point if I cycle the Main pump switch in the galley, it will turn on again, but continue to cycle.
The factory says that I need a new pump, but I am not so sure. There are NO obvious water leaks and cannot detect any air getting into the system.
What now?
Thanks!
This problem has come back! I have plenty of water and have tried the priming technique that Headhunter suggests. My pump will start, and run for about 12 seconds then go to zero and immediately start again. If I keep the water on, after about 5 minutes of cycling, the pump will go into alarm and turn off. At that point if I cycle the Main pump switch in the galley, it will turn on again, but continue to cycle.
The factory says that I need a new pump, but I am not so sure. There are NO obvious water leaks and cannot detect any air getting into the system.
What now?
Thanks!
Bill Johnson
Birmingham, Alabama