04-17-2015, 10:40 AM
The "T" in the first photo is 3/8 NPT. It is threaded directly into the right tag brake chamber. Then the original brake line is threaded into the other end. Then a 3/8" to 1/4" air line fitting is threaded into the third outlet.
You can mount it any where that it will be convenient for you to hook up. Second photo shows where mine is on the lower right. Hard to see air line, but it is just to the left of the electrical connector just above the trailer hitch.
Tom,
Don't forget the torque wrench. Have to torque them to 450 ft lbs.
You can mount it any where that it will be convenient for you to hook up. Second photo shows where mine is on the lower right. Hard to see air line, but it is just to the left of the electrical connector just above the trailer hitch.
Tom,
Don't forget the torque wrench. Have to torque them to 450 ft lbs.
Steve Bare
1999 Newell 2 slide #531