07-29-2014, 07:00 PM
I am in the middle of working on my electrical bay. The current model from Newell is a Surge Guard Model 40250-RVC. Although, I put a new one in a few months ago, an unfortunate leak caused a complete failure of the switch. I ordered a new control board from Newell, and that got me kinda going, but I still needed to manually operate the shore power switch. (I bought a whole new switch to minimize the amount of time that I will be without AC).
So...If you already have a surge guard, I have a control board for you.
I am impressed with the Surge Guard but they are PRICEY!
On a side-but related note...I found that the service wire (from the switch to the breaker box) appears to have gotten really hot at some point in the past. The sheath is melted in places. I am thinking that I will have to either cut the burnt end off, or replace the entire thing.
Cheers,
bill
So...If you already have a surge guard, I have a control board for you.
I am impressed with the Surge Guard but they are PRICEY!
On a side-but related note...I found that the service wire (from the switch to the breaker box) appears to have gotten really hot at some point in the past. The sheath is melted in places. I am thinking that I will have to either cut the burnt end off, or replace the entire thing.
Cheers,
bill
Bill Johnson
Birmingham, Alabama