07-08-2014, 04:06 AM
Can you take a picture of the end? If the end is solid, then it's a temp sensor. If the end has a little hole then it's a pressure sensor. I am assuming it was on the engine, and it was screwed into one of the oil galleys.
What warning lights were on? What was done with the two ends that were attached to the fitting? Were they connected or was the circuit left open? I think you have DDEC? Do you run VMS PC? If so what were those codes?
What warning lights were on? What was done with the two ends that were attached to the fitting? Were they connected or was the circuit left open? I think you have DDEC? Do you run VMS PC? If so what were those codes?
Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home
)